Height Adjustment - Vestil AHS Owner's Manual

HEIGHT ADJUSTMENT

For adjustable height models, the height of the top beam can be adjusted by the following ways:
Never attempt to adjust whil loaded.
A.) Using a forktruck or an overhead crane
1.) Lock all the casters in perpendicular position to one another.
2.) A forktruck or an overhead crane is used to support the top beam.
3.) Release the pin clips from the height adjustment pins on both sides of the frame, and pull out the pins.
4.) The top beam can now be lowered or raised to the desired height with the help of the forktruck or overhead crane.
5.) Insert the height adjustment pins and secure them with the pin clips.
B.) Using the ratchet cable puller (customer supplied)
1.) Lock all the casters in perpendicular position to one another.
2.) Attach one end (hook) of the ratchet cable puller to the bracket (position A) on the leg assembly, and the other end
to the end of the side frame (position B). Please refer to figure below: Figure 3
3.) Tighten the cable to hold the side frame in place.
4.) Release the pin clip from the height adjustment pin, and pull out the pin.
5.) The top beam can now be lowered or raised to the desired height by extending the cable, or shortening the cable.
6.) Insert the height adjustment pin and secure it with the pin clip.
7.) Repeat the above procedures for the other side.
CAUTION: NEVER STAND BELOW THE TOP BEAM WHILE TRYING TO ADJUST THE HEIGHT !
Supplied Cable
when purchasing
AHA-KIT
Ratchet
Cable Puller
Side Frame
Pin Clip
Height Adjustment Pin
Position A
Leg Assembly
Position B
Figure 3
E
N
G
L
I
S
H
3