Configuration - Detecto VET-330WH Owner's Manual

The VET-330WH scale has been pre-configured at the factory and should not require
changes to use in most applications. If the factory settings do not meet the requirements of
your application, the following describes the steps to change the configuration of the scale.
To Begin Configuration:
1. Press the ON/ZERO/OFF key to turn on the scale.
2. Press and hold the TARE key for 3 seconds.
3. When the display shows
Configuration mode with the display showing
Weighing Units
To select "kg" (kilogram) weighing units:
1. With the display showing
show "kg".
2. Press the HOLD key to display kg status.
3. Press the UNIT key to toggle between:
Enable (display will change to
Disable (display will change to
4. Press the HOLD key. The display will change to
5. Proceed to Automatic Shutoff.
To select "lb" (pounds) weighing units
1. With the display showing
display will change to show "lb".
2. Press the HOLD key to display lb status.
3. Press the UNIT key to toggle between:
Enable (display will change to
Disable (display will change to
4. Press the HOLD. The display will change to
5. Proceed to Automatic Shutoff.
Automatic Shutoff
1. With the display showing
to show
2. Press the HOLD key to begin the selection of the automatic shut-off time (in
seconds). The display will change to show
3. Press the UNIT key to toggle through the selections,
4. When the desired time is displayed, press the HOLD key. The display will change to
show .
5. Proceed to Gravity Compensation.
1961-M045-O1 Rev B VET-330WH Owner's Manual

CONFIGURATION

, release the TARE key. The scale will enter the
, press the HOLD key. The display will change to
, press the HOLD key and then the UNIT key. The
, press the press UNIT key. The display will change
.
.
) or
).
.
) or
).
.
.
, , , , or .
9