Download  Print this page

Programming Your Remote; Direct Code Entry - GE 24914 Instruction Manual

Ge 24914: user guide
Hide thumbs

Advertisement

Table of Contents

Programming Your Remote

Your GE universal remote control is designed to
control multiple audio/video devices such as TV,
DVD, DVR, satellite, cable and audio using only one
remote. To use this remote, you will need to program
it to control the devices of your choice. There are two
ways to program the remote - direct code entry or
auto code search.
Direct Code Entry (Recommended)
1. Locate the Remote Code List provided
in this manual. Find the DEVICE
CATEGORY you wish to program (for
example TV, DVD, CBL/SAT, DVR/
AUX) and then find the BRAND of that
device. Circle all the codes under that
brand. Example: For a GE TV, locate the
TV code section then circle all of the
GE TV codes.
2. Manually turn on the device you wish
to control.
3. Press and hold the SETUP button
until the red indicator light stays on
(approximately 4 seconds) and then
release the SETUP button.
4. Press and release the desired device
button on the remote (TV, DVD, CBL/
SAT, DVR/AUX). The red indicator will
blink once and then remain on.
5. Enter the first 4-digit code previously
found in the code list using the
number buttons on the remote. If the
code entered is a valid code, the red
indicator light will turn off. If the code
entered is not a valid code, the red
indicator light will flash and remain on
allowing you to re-enter the code.
Note: If no buttons are pressed for 10
seconds, the remote will exit the SETUP
mode and you will have to start over.
6

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

  Also See for GE 24914

  Related Manuals for GE 24914

This manual is also suitable for:

249122494424911250201156111560 ... Show all