Lightcloud LCCONTROL/MINI Manual page 9

Setup & Installation
Labeling Your device
3
When installing devices, it's important to keep track of their Device
IDs, installation locations, panel/circuit #s, dimming function, and any
additional notes. To organize this information, use the Lightcloud
Installer Application (A) or Device Table (B).
3a
Install the LC Installer Application: LC Installer is available
for iOS and Android.
Scan & Install Lightcloud Devices: Scan each device and
assign to a room. It's recommended that each device is
scanned just before or just after being wired so no devices
are missed. The more notes that are given, the easier it is to
commission the system.
Lightcloud Installer Application
Device Scanner
PLACE RECTANGLE TO FIT CODE ON LABEL
Enter Manually
Scan Device Code
Device Scanner
PLACE RECTANGLE TO FIT CODE ON LABEL
Enter Manually
Repeat for Additional Devices
(cont'd)
Device Info
Device ID
0013A20040B62A4A
Location
Office
Zone Name
Office Lights
Dimmable
Power Monitoring
Cancel Save
Enter Device Information
Devices
Office Light - ID 0013A20040B62A4A
Controller
Office Light - ID 0013A20040B62A4B
Sensor
Office Light - ID 0013A20040B62A4C
Dimmer
Office Light - ID 0013A20040B62A4D
Daylight
Office Light - ID 0013A20040B62A4E
Touch
Send to RAB Add Device
Send to RAB