Disconnect Dc Power; Reconnect Dc Power - Cisco 8800 Series Hardware Installation Manual

Replace Chassis Components
Step 5
Move the handle up.
Step 6 Tighten the screw that secures the power module using a Phillips screw driver.
Caution
Step 7
Verify that the (green) Power Input indicator on the front of the power module goes on.

Disconnect DC Power

Procedure
Step 1 Power off the circuit breaker assigned to the DC power source you are disconnecting.
Caution
Step 2
Remove the clear plastic safety covers that fit over the DC power connection terminal studs.
Caution
Step 3 Disconnect the DC power cables from their terminals in the following order and note the color of each cable.
a) Negative (PWR) cables first.
b) Positive (RTN) cables last.
Step 4
Repeat Step 1 through Step 3 for the other power tray, if installed.
Caution

Reconnect DC Power

Follow these steps to reconnect DC power to a DC power tray:
Procedure
Step 1 Set the power switch to the OFF (0) position.
Step 2
Check that the circuit breaker assigned to the DC power source you are reconnecting is powered OFF (0).
Step 3 Reconnect the DC power cables in the following order.
a) Positive (RTN) cables first.
b) Negative (PWR) cable last.
c) Repeat Step 1 through Step 3 for the other power trays.
To prevent damage to the power tray backplane connector, do not use excessive force when inserting
the power module into the power tray.
To ensure that power remains off while you are performing this procedure, lock-out/tag-out the
circuit breaker switch in the STANDBY (0) position until you are ready to turn it on.
To prevent injury and damage to the equipment, always remove the source DC power cables and
ground from the power tray terminals in the following order : (1) negative (–), (2) positive (+).
It is not necessary to disconnect all power from the router to replace components, including power
modules.
Hardware Installation Guide for Cisco 8800 Series Routers
Disconnect DC Power
129