Safety; Check On Operation; Final Remarks - Chamberlain LiftMaster UGO300M Instructions Manual

CHECK ON OPERATION

Activate the function "Automatic close" on the control unit. If
the gate opens automatically after the preset time, exchange
the brown and black leads.
Most control units have a time function. This should always
be set to about 3 - 5 seconds more than the time actually
required. The preliminary setting should be made somewhat
more than this, to allow a safety margin; after the necessary
adjustments to the system have been made, the time can be
set more accurately. NB: The drive works more slowly
under windy conditions.
SAFETY MEASURES
An automatically operated wing gate should always
be further protected with the aid of flashing lights,
contact strips and photoelectric barriers. In any
case, take care to comply with the relevant
standards and regulations.

FINAL REMARKS

Arrange the handover of the wing gate opener with your
customer Make sure that persons will operate the gate are
familiar with its functions and can operate them without
problems. Have your customer practice operating the gate
until he is fully acquainted with all the following:
• Main switch.
• Rules of operation (e.g. do not drive through while the gate
is still opening).
• Additional safety features (photoelectric barrier, contact
strip, flashing lights, etc.).
• Switch to manual operation in case of power failure.
• Provide the customer with a full set of instructions. Inform
him to keep them in a safe place and read them when
possible.
• Reference a checklist, so that you have a record of
which functions have been explained and of any points not
dealt with.
709154
ACCESSORIES
(1) Model FLA230-2
(2) Model 100263
(3) Model 100027
Model 100041
(4) Model 600046
(5) Model 600053
(6) Model 600060
(7) Model 600152
(8) Model 600077
(9) Model 600145
(10) Model 600138
(11) Model 600176
(12) Model 600169
(13) Model 600008
(14) Model 600015
© Chamberlain GmbH, 2000
12
Flashing Light
Infrared barrier
1-Function Keyswitch,
surface mount
(Flush mount - 100010)
2-Function Keyswitch,
surface mount
(Flush mount - 100034)
2.5 Safety Edge Set (Small)
20m Bulk Pack Safety Edge
Profile (Small)
Assembly Pack Safety Edge
(Small)
Assembly Pack Safety Edge
(Medium/Large)
Bulk pack (not shown)
20m Bulk Pack Safety Edge
Profile (Large) (not shown)
20m Bulk Pack Safety Edge
Profile (Medium) (not shown)
1m Safety Edge Profile (Large)
(not shown)
1m Safety Edge Profile (Medium)
(not shown)
IR Sensor Stand - 530mm
Key Switch Stand - 1100mm