Advertisement
3. Two layer (double stacked) applications.
Sensor #1
Sensor #2
Tx
Rx
Rx
Ch1
Ch1
Ch1
Sensor #4
Sensor #5
Tx
Rx
Rx
Ch3
Ch3
Ch3
4. Perimeter security application.
Rx
Ch2
Tx
Ch1
Rx
Ch3
Tx
Ch4
5. Two layer (double stacked) perimeter security application.
Tx
Ch2
Rx
Ch4
Ch2
Ch4
Rx
Ch1
Ch3
Tx
Ch1
Ch3
Sensor #3
Tx
Tx
Rx
Ch1
Ch2
Ch2
Sensor #6
Tx
Tx
Rx
Ch3
Ch4
Ch4
Tx
Ch3
Rx
Ch4
Tx
Ch2
Rx
Ch1
Tx
Ch1
Ch3
Tx
Ch2
Ch4
8
Wiring the Transmitter – Pole Mount
(NOTE – Pole mounting bracket required.)
1. Remove the cover. Remove the screw under
the lens unit in order to detach the mounting
plate. See fig. 4.
2. Break a hole in the mounting plate's rubber
grommet, and pull the cable through the
grommet's hole. Then run the cable through
the hole near the top of the sensor unit so it
comes out the front. Use the included
mounting bracket to mount to the pole. Then
Fig. 4: Remove the Transmitter cover
Fig. 6: Wall Mount, Wire Runs Along Wall
Rx
Ch1
Ch3
Rx
Ch2
Fig. 8: Wiring
Transmitter
Ch4
1
2
12/24
AC/DC
Power
12~ 24 VAC/VDC
(non-polarized)
reattach the sensor unit to the mounting plate,
connect the wires, and snap on the cover.
See fig. 7.
Wiring (fig. 8)
1. Screw the wires tightly to avoid slipping off the
terminals, but not so tight that they break.
2. Screws on terminals which are not used
should be tightened.
3. Grounding may be necessary, depending on
the location.
Fig. 5: Wall Mount, Wire from Inside Wall
Fig. 7: Pole Mount
– or –
Receiver
6
7
1
2
12/24
N.C.
AC/DC
Tamper output
Power
N.C. switch 120V (AC/DC) 1A
12~ 24 VAC/VDC
(Triggers if cover detached)
(non-polarized)
5
3
4
5
6
7
N.C.
COM.
N.C.
N.O.
Tamper output
Alarm output
N.C. switch 120V (AC/DC) 1A
120V (AC/DC) 1A
(Triggers if cover detached)
Advertisement
