Control Panel - Secabo T60 II Operating Instructions Manual

Control panel
Initial operation of machine and software
Caution! Please note that the smooth installation and complete configuration
requires DrawCut PRO to be installed first.
Installation DrawCut PRO
Your Secabo vinyl cutter is delivered with the cutting software DrawCut PRO. This software must
be activated over the Internet. You do not necessarily need internet access on the computer, on
which DrawCut will be installed. The activation can also be done on another computer.
In order to control your vinyl cutter via your computer, install the software as described below:
● Disable the Windows Firewall and your anti­virus software for the time of installation.
● Download the current version of DrawCut PRO at http://www.draw­cut.com/#downloads
and follow the installation wizard.
● Find your 26­digit DrawCut serial number on the printout that was delivered with your vinyl
cutter. Enter it when you are prompted to do so.
● Now you can use DrawCut PRO.
Installation of your Secabo vinyl cutter in DrawCut
Please keep in mind that your Secabo vinyl cutter can only be operated under Windows XP,
Windows Vista, Windows 7, Windows 8, Windows 8.1 and Windows 10. Operation with an older
version of Windows is not possible.
● First, make sure that your PC is connected to the Internet.
Secabo GmbH | Hochstatt 6­8 | 85283 Wolnzach | Germany | mail@secabo.com | www.secabo.com
7