Initial Operation Of The Device; Installing And Adjusting The Blade; Inserting The Blade Holder - Secabo T60 II Operating Instructions Manual

Initial operation of the device
Make sure that there is sufficient space for the film transport in front of and behind the device. The
cutter may only be operated in a clean and dry environment.
● Connect the vinyl cutter to a 230 V socket using the supplied power cable.
● Now switch on the cutter.
Installing and adjusting the blade
● Take the supplied cutting blade and place it in the blade holder in such a way, that the
sharp side extends at the front.
● Now set the cutting depth by turning the screw at the upper end of the
● Initially, the depth is correctly set if you can carefully move your fingertip across the blade
and feel only a light scratching. Since the depth adjustment for the blade depends on the
material, it may be necessary to adjust it later.
● Secure the blade setting by tightening the gold lock nut.
● Press the pin on the rear end of the blade holder to remove and replace the blade at any
time. Caution ­ risk of injury!
The various material thicknesses require different blade settings or even special blades; it may
therefore be necessary to repeat the adjustment described above.
Inserting the blade holder
● First, sufficiently loosen the clamping screw for the blade holder on the cutting head.
● Next, press down the blade holder from above into the hole on the right side until there is
contact and pull the lock nut tight. In doing so, please ensure that the blade holder is also
secured correctly from above by means of the fixture provided for this purpose.
a) Clamp
Secabo GmbH | Hochstatt 6­8 | 85283 Wolnzach | Germany | mail@secabo.com | www.secabo.com
10
blade holder.