OttLite L15BN7 Quick Manual

13w Vero Table Lamp
L15BN7 T59BNR
INS90011 REV102309
ENGLISH

CONGRATULATIONS!

OPERATION

1. Tighten or loosen the pivot joint
You've purchased the finest in natural
lighting technology with your new of the shade (E) as needed using the
OttLite product. thumbscrew (F).
®

PRODUCT REGISTRATION FORM

2. Plug power cord into a standard
Please complete the enclosed Product 120V wall outlet.
Registration Form and return it today
by mail, or register online by going to: 3. To turn the lamp on or off, depress the
www.ott-lite.com/warranty. rocker switch (G) located on the base.
WARNING: To prevent electric shock, Please note that in operation,
make sure the lamp is not plugged in OttLite
until all assembly steps are complete.
Enjoy your OttLite

INSERT STARTER

1. Position the starter (B) so that the This lighting system is designed for
silver contacts line up with the holes in use with OttLite
the starter holder (A). Press gently and number B132S3 / T57J3M). Use of
other products voids the warranty
turn clockwise until the starter locks
into place. and may result in damage to the
lighting system.
2. Install the barrel handle (C) by placing
it over the starter (B) and screwing
clockwise onto the lampshade bar.

TUBE INSERTION/REPLACEMENT

1. Make sure that the lamp is not plugged
into an electrical outlet.
2. If the lamp has been in use, allow it
to cool approximately five minutes before
proceeding.
3. Align the two pins at the end of the
tube (D) with the slots in the shade (E)
sockets.
4. Hold tube in place by grasping top of
shade (E) with hand and using thumbs to
hold tube (D). Thumbs should be on the
plastic ends of the tube.
5. Push the ends into each socket and
rotate 90 degrees in either direction until
the tube "snaps" into place.
CAUTION!
If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer
or its service agent or a similar qualified person in order to avoid a hazard. Indoor use only.
Vero Table Lamp
CAUTION! IMPORTANT SAFETY INSTRUCTIONS:
THIS PORTABLE LAMP HAS A POLARIZED PLUG (ONE BLADE IS WIDER THAN THE OTHER) AS A FEATURE TO
REDUCE THE RISK OF ELECTRIC SHOCK. THIS PLUG WILL FIT IN A POLARIZED OUTLET ONLY ONE WAY. IF THE
PLUG DOES NOT FIT FULLY IN THE OUTLET, REVERSE THE PLUG. IF IT STILL DOES NOT FIT, CONTACT A
QUALIFIED ELECTRICIAN. NEVER USE WITH AN EXTENSION CORD UNLESS PLUG CAN BE FULLY INSERTED.
DO NOT ALTER THE PLUG.
CAUTION:
FULLY INSERT.
® tubes are not dimmable.
Vero Table Lamp!
®
¡ PRECAUCIÓN! INSTRUCCIONES DE SEGURIDAD
tubes only (model
®
IMPORTANTES:
ESTA LÁMPARA PORTÁTIL TIENE UN ENCHUFE POLARIZADO (UNA DE SUS PATAS ES MÁS ANCHA QUE LA OTRA)
COMO CARACTERISTICA PARA REDUCIR EL RIESGO DE UNA DESCARGA ELÉCTRICA. ESTE ENCHUFE ENCAJARÁ EN
CUALQUIER TOMACORRIENTE POLARIZADO SOLO DE UNA MANERA. SI EL ENCHUFE NO CALZA COMPLETAMENTE
EN EL TOMACORRIENTE DÉLE LA VUELTA. SI AÚN NO ENCAJA, PÓNGASE EN CONTACTO CON UN ELECTRICISTA
CALIFICADO. NUNCA UTILICE UNA EXTENSIÓN A NO SER QUE EL ENCHUFE PUEDA SER TOTALMENTE
INSERTADO. NO ALTERE EL ENCHUFE.
PRECAUCIÓN:
ENCHUFE CON LA RANURA ANCHA, INSERTE TOTALMENTE.
AVERTISSEMENT! IMPORTANTES DIRECTIVES DE
SÉCURITÉ:
CETTE LAMPE PORTATIVE EST MUNIE D'UNE FICHE POLARISÉE (UNE LAME PLUS LARGE QUE L'AUTRE). CE
DISPOSITIF DE SÉCURITÉ DIMINUE LE RISQUE DE CHOCS ÉLECTRIQUES PUISQUE LA FICHE NE S'INSÈRE DANS
LA PRISE QUE D'UN SEUL CÔTÉ. SI ELLE N'ENTRE PAS DANS LA PRISE, INVERSEZ-LA. SI ELLE N'ENTRE
TOUJOURS PAS, CONTACTEZ UN ÉLECTRICIEN QUALIFIÉ. N'UTILISEZ JAMAIS AVEC UNE RALLONGE SAUF SI
LA FICHE S'INSÈRE ENTIÈREMENT. NE MODIFIEZ PAS CE DISPOSITIF DE SÉCURITÉ.
AVERTISSEMENT:
DANS LA GRANDE FENTE ET POUSSEZ JUSQU'AU BOUT.
TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT,
PARA PREVENIR UNA DESCARGA ELÉCTRICA, HAGA COINCIDIR LA PATA ANCHA DEL
POUR ÉVITER LES CHOCS ÉLECTRIQUE, INSÉREZ LE BOUT LARGE DE LA FICHE