Related Manuals for Pyle PYWM24
Summary of Contents for Pyle PYWM24
- Page 1 PYWM24 TV Wall Mount Bracket Fits for 26-52'' LED/LCD/OLED & Plasma Flat Screen TV with 2x Standard Weight Support, Weight Up to 110lbs.
-
Page 2: Part List
CAUTION: Please read this instruction carefully before assembly. • Fits for 26-52" plasma and LCD TV. • Weight Capacity: 50Kg (110Lbs). CAUTION: SAFETY WARNING: • Never let children climb on product or play with product. • Do not sit or stand on product. •... -
Page 3: Wall Mounting Hardware
WALL MOUNTING HARDWARE TV MOUNTING HARDWARE Step 1: Remove the plaster board on the surface of concrete wall when assembling mount on the concrete wall. Hold Wall plate (A) against wall at desired position on concrete wall, then using a pencil mark 4 hole locations. Then drill holes according pencil marks using 3/8"... - Page 4 If you mount TV mount into wood studs, pre-drill the mark 4 holes using 7/32" drill bit to a depth of 2.5", x Wall plate (A) to the wall with lag bolt and washers (Figure 2) CAUTION: The wood stud min size is 2x4 inches, and surface covering can't more than 5/8 inches.
- Page 5 Step 2: Putting the brackets (B) on a at table, then insert adjusting pole( C ) into brackets and locking screw tightly. CAUTION: You only need to insert the adjusting pole in the center of the two brackets on this step. DO NOT twist the adjusting pole during the inserting process. Adjusting pole (C) bolt Step 3: Attach TV Bracket (B) to the back of TV, choose corresponding bolt, washer...
- Page 6 g\h\i\j h\i\j Figure 4 Step 4: Hang the pre-assembled TV unit on the Wall Plate. Pull down to release the safety catch on both Brackets to attach the assembly to the bottom part of the Wall Plate. (Figure 5) CAUTION: This step must require 2 or more professional to nish.
- Page 7 Step 5: Tighten the safety screws. (Figure 6 ) Figure 6 Step 6: Adjust angle by loosening thea djusting pole (C) to allow the Brackets to tilt forward up to 0°/-15 d°egrees. (Figure 7) Once the desired tilt angle is achieved, tighten the all screws to secure the television in the new position.
-
Page 8: Product Dimensions
PRODUCT DIMENSIONS: 633mm 0 ~-15° MAX:500mm MAX:400mm 425mm 68mm PAY EXTRA CARE AND ATTENTION WHEN YOU FASTEN TWO TV MOUNTS TO THE BACK PANEL OF TV IN STEP 2. MAKE SURE THE APPROPRIATE MOUNT HARDWARE IS BEING USED PROPERLY. 1. Select correct Mounting Hardware according to the screw hole size of your TV, discard any remaining screws or spacers. - Page 9 PYWM24 TV Wall Mount Bracket Fits for 26-52'' LED/LCD/OLED & Plasma Flat Screen TV with 2x Standard Weight Support, Weight Up to 110lbs. Features: • Fits for 26'' to 52'' TV or Fits for 16’’ Studs Plus Concrete Wall •...
- Page 10 Questions? Issues? We are here to help! Phone: (1) 718-535-1800 Email: support@pyleusa.com...