IBM RS/6000 7046 Service Manual page 67

All manuals and user guides at all-guides.com
Error Code Function
/Description
20E00005 EEPROM locked.
20E00008 CMOS corrupted or
tampering evident,
CMOS initialized.
20E00009 Invalid password
entered - system
locked.
20E0000A EEPROM lock
problem.
20E0000B EEPROM write
problem.
20E0000C EEPROM read
problem.
20E00017 Cold boot needed
for password entry.
20EE0xxx Informational
20EE0003 IP parameter
requires 3 dots "."
20EE0004 Invalid IP parameter.
20EE0005 Invalid IP parameter
(>255).
20EE0006 No SCSI controllers
present.
20EE0007 Keyboard not found.
20EE0008 No configurable
adapters found in
the system.
Repair Action/Possible Failing FRU
1. Turn off, then turn on the server.
2. Replace system board (see note 3 on page 2-1).
Check your machine for evidence of tampering.
If NO tampering:
1. Replace battery, restore NVRAM data (passwords,
startup data).
2. Replace system board (see note 3 on page 2-1).
The password has been entered incorrectly 3 times.
Turn off, then turn on the server, then enter the
password correctly.
If for privileged-access password install, is jumper in
correct position?
Consult the server User's Guide for pin location and
jumper position.
1. Turn off, then turn on the server.
2. Replace system board (see note 3 on page 2-1).
1. Turn off, then turn on the server.
2. Replace system board (see note 3 on page 2-1).
1. Turn off, then turn on the server.
2. Replace system board (see note 3 on page 2-1).
Turn off, then turn on the server.
Enter valid IP parameter
Example: 000.000.000.000
Enter valid (numeric) IP parameter
Example: 000.000.000.000
Enter valid (numeric) IP parameter in the range of 0 to
255
Example: 255.199.002.000
The system board should always have at least 2
integrated PCI SCSI controllers. Replace the system
board (see note 3 on page 2-1).
1. Plug in keyboard
2. Replace system board (see note 3 on page 2-1).
This warning occurs when the selected SMS function
cannot locate any devices/adapters supported by the
function. If a supported device is installed:
1. Replace the device or adapter.
2. Replace system board (see note 3 on page 2-1).
Chapter 3. Error Code to FRU Index
3-3