IBM RS/6000 7046 Service Manual page 98

The AB value identifies a bus type or PCI parent bus as assigned by the
firmware.
The CD value identifies adapter number, adapter's devfunc number, or physical
location. The devfunc number is defined as the PCI device number times 8, plus
the function number.
The EF value identifies a connector.
The GH value identifies a port, address, device, or FRU.
Adapters and cards are identified with AB-CD.
The possible values for AB are:
00 Processor bus
01 ISA bus
02 EISA bus
03 MCA bus
04 PCI bus used in the case where the PCI bus cannot be identified
05 PCMCIA buses
xy For PCI adapters where x is equal to or greater than 1. The x and y are
characters in the range of 0-9, A-H, J-N, P-Z (O, I, and lowercase are
omitted) and are equal to the parent bus's ibm, aix-loc Open Firmware
Property.
The possible values for CD depend on the adapter/card:
For pluggable PCI adapters/cards, CD is the device's devfunc number (PCI
device number times 8, plus the function number). The C and D are characters
in the range of 0-9, and A-F (hex numbers). Location codes therefore uniquely
identify multiple adapters on individual PCI cards.
For pluggable ISA adapters, CD is equal to the order the ISA cards
defined/configured either by SMIT or the ISA Adapter Configuration Service Aid.
For integrated ISA adapters, CD is equal to a unique code identifying the ISA
adapter. In most cases, this code is equal to the adapter's physical location code.
In cases where a physical location code is not available, CD is FF.
EF is the connector ID, used to identify the adapter's connector to which a resource
is attached.
GH is used to identify a port, device, or FRU. For example:
4-4
7046 Model B50 Service Guide
All manuals and user guides at all-guides.com