Napa CARLYLE TW12QR Manual page 4

REPLACING THE HEAD KIT (CONT.)
Step 2: Place springs under the left and right pawls. Note
the small end of the spring should face the pawl. Place
Drive in space between the wall and the pawls. See fig. 2
Step 3: Place the plate on the back and then holding in
place turn the wrench over. See fig. 3
Step 4: With the front plate in place insert the two screws
into the holes and use a screwdriver and a T15 bit to
tighten quarter past snug. See fig. 4
Step 5: Flip select lever from CW to CCW taking time to
spin the drive in each direction with each flip. See fig. 5
TW12QR
Fig. 3
Fig. 4
Fig. 5
4
Fig. 2
Rev. 12/16/13