How To Manage: Error Codes - AEG BPE748280M User Manual

TROUBLESHOOTING
Components
Description
The lamp is burnt out.
Power cut always stops cleaning. Repeat cleaning if it's interrupted by power failure.
Problems with Wi-Fi signal
Possible cause
Trouble with wireless network signal.
New router installed or router configuration
changed.
The wireless network signal is weak.
The wireless signal is disrupted by a micro‐
wave appliance placed near the oven.

12.2 How to manage: Error codes

When the software error occurs, the display shows error message.
In this section, you will find the list of the problems that you can handle on your own.
Code and description
C2 - the Food sensor is in the oven cavity dur‐
ing Pyrolytic Cleaning.
C3 - the door is not fully closed during Pyrolyt‐
ic Cleaning.
114/372
Remedy
Replace the lamp, for details refer to "Care and
Cleaning" chapter, How to replace: Lamp.
Remedy
Check your wireless network and router.
Restart the router.
To configure oven and mobile device again, re‐
fer to "Before first use" chapter, Wireless con‐
nection.
Move router as close to the oven as possible.
Turn off the microwave appliance.
Remedy
Take out the Food sensor.
Close the door.