Operating Instructions; Activation Instructions - Primula Vapormat Instruction Manual

5.Operating Instructions

For the instructions mentioned in the current section please see the below picture 2.

5.1. Activation Instructions

54
 Fill with clean water the feedwater vessel 25lts( No 41).
 Turn on the water inlet valve(Ball valve ½, No 26) in order to permit the water
circulation in the machine.
 Turn on the main switch (No 31) and press the button ON on the keyboard.
The water pump starts to feed water the boiler. The green light No 2 (PUMP ON) of the
control keyboard (No 54) should be on. After a while, the green light No 1 (STEAM ON)
on the control keyboard, should be on. The boiler starts heating the water in order to
supply steam in about 15-20 min. (In case you have a model carrying a 6KW the heating
element the requested time for steam preparation is 9-11 min). The manometer should
reach 3,5 bars. The machine is ready to work.
 Press the iron's buttons on the control keyboard. Press only one button if the
requested produced steam is for 1 steam iron, or both buttons if the requested
produced steam is for 2 steam irons.
 Adjust the temperature of the iron, by the thermostat knob, according to the fabric
requirements.
 Adjust the steam consumption by the adjustor knob No 37, according to the fabric
requirements. You can start ironing!
In case of purchasing the Vapormat/3-6, turn on the switch of AD/5 cell for supplying
steam to the third iron.
WARNING ! To avoid burning accidents ,follow carefully the instructions below:
Fill the condensate vessel C (sketched below) with water,at a level of 5 cm.approximately.
Screw tightly cap D.Unlock safety blocker A.Turn on slowly the outlet valve B in order to
remove any water condensates from the boiler. After finishing, turn off the outlet valve B
and lock again safety blocker A.
Picture 2: Steam Genarator "Vapormat"
8
Instruction Manual VARORMAT