Table of Contents
Advertisement
4.3 Device Installation
IOT-CPE5G supports multiple installation methods like desktop, wall mounting, pole mounting, etc.
Before you start, make sure that your SIM card has been inserted and all cables have been installed.
Note:
Do not connect device to power supply or other devices when installing.
4.3.1 Desktop
When using indoors, pile 4 rubber feet into the gaps at the bottom of the device. The rough surface of
rubber feet should face desktop.
4.3.2 Wall Mounting
Preparation: mounting bracket(with 2 screws), wall plugs, wall mounting screws and other required
tools.
A. Align the mounting bracket horizontally to the desired position on the wall, use a marker pen to mark
four mounting holes on the wall, and then remove the mounting bracket from the wall.
Note: The connecting lines of adjacent points are at right angles.
B. Drill four holes with a depth of 32 mm by using your drill with a 6 mm drill bit on the positions you
marked previously on the wall.
C. Insert four wall plugs into the holes respectively.
D. Mount the mounting bracket horizontally to the wall by fixing the wall mounting screws into the wall
plugs.
E. Hang the device to the mounting bracket via bracket mounting screws on the back of device, then
screw the 2 bracket screws to the bottom of the device.
9
Advertisement
Table of Contents
