Waterproof Cover & Ethernet Cable Installation - LINOVISION IOT-CPE5G Quick Start Manual

4.2 Waterproof Cover & Ethernet Cable Installation
If you need to use IOT-CPE5G outdoors, the waterproof cover and cable gland should be installed
under the bottom of the device.
A. Install the rubber ring into the bottom of the device. Note that the round part needs to face the gap of
bottom when installing, otherwise it may cause waterlogged.
B. Connect a round Ethernet cable to LAN1/WAN port, then pass the Ethernet cable through all parts of
the cable gland and the bottom cover.
C. Fix the bottom cover to the bottom of the device with 4 screws.Note that the arrow behind the cover
needs to face the bracket mounting screws.
Note: Bottom cover can be fixed with the device via the wiring behind the cover.
8