Set Up The Terminal Window; Power On The Board; Figure 6 Zdvr Startup Message - Z3 Technology Z3-DM368-ZDVR User Manual

Player and recorder application high definition video processor module dm368-zdvr rapid prototyping system

Table of Contents

5.3 Set up the Terminal Window

(5) If you are running from a Windows PC, run TeraTerm. Select "Setup – Serial Port" and set the

following:

Port:

Whichever serial port the port is connected to

Baud Rate:

115200

Data:

8-bit

Parity:

None

Stop:

1-bit

Flow Control: None

(6) If you are running from Linux, type:

# sudo minicom –s

And then configure by doing the following:

-Select "Serial Port Setup"

-Ensure the right Serial Device is specified (typically "/dev/ttyUSB0")

-Set option E ("Bps/Par/Bits") to 115200 8N1

-Press <return>

-Select "Exit"

(7) Connect the 5V power supply and turn on the switch. If all is configured properly, you should see the

board booting up within the terminal window. After about a minute, you will see the app load up and

the words "Preloading gstreamer components" – once you see that, the ZDVR app is ready to go.

___________________________________________________________________________________________

Z3 Technology, LLC ♦ 100 N 8

CONFIDENTIAL

ST, STE 250 ♦ Lincoln, NE 68508-1369 USA ♦ +1.402.323.0702

Z3-DM368-ZDVR V1.03.01

Table of Contents