Assemble Bench Components - PRx Performance Profile Incline Folding Bench Quick Start Manual

Assemble Bench Components

1. Remove the bench components from their boxes (Figure 1).
WARNING: Bench components are heavy and may require 2 people to lift.
1. Remove the bench components from their boxes. (Figure 1) WARNING: Bench components are
2. Place the leg assembly portion face down as shown below, and remove the shrink wrap
heavy, and may require 2 people to lift.
holding the hardware to the leg and make sure all hardware is accounted for.
2. Place the leg assembly portion face down as shown below, and remove the shrink-wrap holding the
3. Attach the leveling feet to the bottom of the front leg (Figure 1a).
hardware to the leg and make sure all hardware is accounted for.
4. Unfold the legs by grabbing the wall bracket and lifting it 1/4 of the way up, then grab
3. Attach the leveling feet to the bottom of the front leg, as shown in Figure 1a.
the middle leg below that and lift up both simultaneously. This allows the bench to unfold
4. Next un-fold the legs by grabbing the wall bracket and lifting it 1/4 of the way up, then grab the middle
leg below that and lift up on both simultaneously. This is necessary to allow the bench to unfold com-
completely (Figures 2 & 3).
pletely. (Figures 2&3)
5. Next place the pad/seat assembly face down and attach the handles with the #10 screws provided in
the hardware pack. (Figures 4&5)
Leg Assembly
Leveling
Feet
Figure 1a
2
Assemble Bench Components
Figure 1
Figure 1
Figure 2
(701) 566-0452
Figure 3
support@prxperformance.com 701-566-0452
the hardware pack. (Figures 4&5)
Leg Assembly
Leveling
Feet
Figure 1a
Pad/Seat Assembly
Figure 5
Figure 1
Figure 2
Figure 2
Figure 4
Figure 3
Figure 3
support@prxperformance