Operating In Offline Mode; Operating Modes; Setpoint Temperature Change (Manual Mode) - Computime Salus Controls iT500 Full User Manual

8. Operating in OFFLINE MODE

8.1 Operating modes

- automatic mode
(works according to the schedule)
1
Press the power button
to highlight the display.

8.2 Setpoint temperature change (manual mode)

iT500TR is in manual mode by default. To change setpoint temperature please look at the steps below:
Note: If you set the temperature in AUTO mode (temporary override), then new setpoint temperature will be maintained until the next
program starts by schedule.
1
Press the power button
to highlight the display.
40
Permanent manual mode
2
Press and hold and
buttons for 3 sec.
2
Press button to select heating
zone or DHW.*
*(only in two heating zones or one
heating zone + hot water system)
- antifrost mode 5°C
(changing temperature is avaible only
through the app)
3
1
Press or
to select operating mode.
Press button to confirm.
3a
Press or
to change temperature.
Press button to confirm.
3b
Set hour value of boosting your hot
water by pressing
button. Press
confirm.
AUTO
button
button
or
button to