Q 2.2 Vehicle Preparation; Q 2.2.1 Removing Handle - Ranger design 3320-PC Installation Manual

PHASE 2 – INSTALLATION
2.2 VEHICLE PREPARATION
2.2.1 Removing handle.
NOTE: If you are installing a Composite Partition and your Promaster City is supplied with an oversized sliding
door handle, this handle must be removed in order for the door to close properly.
For technical support, contact us at 1-800-565-5321
Separate the two halves of the handle exposing the
two bolts at the top by removing the small philips
screws and the bolt at the bottom.
TOOLS
q Cordless Impact or Ratchet
q Philips Screw Driver
q T30 Torque Bit
Detach the plastic bracket on the cable from
the metal part of the handle, then slide the ca-
ble across the channel and pop out.
Tape or roll the cable.
NOTE: Pulling the cable unlocked the
door.
3320-PC Installation Guide | REV. J2 | Page 9