Mounting Your Tread Base Edition In A Vehicle; Garmin Powerswitch; Mounting Considerations - Garmin Tread Owner's Manual

Mounting Your Tread Base Edition in a Vehicle

Before mounting the device, check the local laws pertaining to windscreen mounting.
Do not use the suction cup mount on a motorcycle.
See the Important safety and product information guide in the product box for product warnings and other
important information.
NOTE: the vehicle mount is not included with all device models. Go to
accessories.
1 Plug the automotive power cable
2 Remove the clear plastic from the suction cup
3 Clean and dry your windscreen and the suction cup with a lint-free cloth.
4 Press the suction cup to the windscreen, and flip the lever
5 Snap the cradle onto the suction-cup arm.
6 Fit the bottom of your device into the cradle.
7 Press the device into the cradle until it snaps into place.
8 Plug the other end of the automotive power cable into a power outlet.

Garmin PowerSwitch

Garmin strongly recommends having an experienced installer with the proper knowledge of electrical systems
install the device. Incorrectly wiring the power cable can result in damage to the vehicle or the battery and can
cause bodily injury.
You can use a connected Garmin PowerSwitch device to control lights, fans and more from your Tread device.

Mounting Considerations

• The device must be mounted close to the battery and within the range of the supplied power cable.
• The mounting surface must be strong enough to support the weight of the device.
• The location must allow room for the routing and connection of all cables.
Appendix
NOTICE
WARNING
into the port on the device.
.
WARNING
garmin.com to purchase optional
back toward the windscreen.
63