Advertisement
To Adjust the Flip Stop
• Flip up the flip stop.
• Slide the flip stop along the fence to the desired position.
• Flip the stop down to lock into position on the fence.
Figure 12
Flipped UP
Hold Down Clamps
Refer to Figure 13
Slide the T-Bolts on hold-down clamps into the table
T-Track slots.
Figure 13
Table T-Track
Hold-
Slot
Down
Clamp
5/16"-18
x 3-1/2"
T-Bolt
To Adjust the Hold Down Clamps
• Loosen knob on the hold down clamp.
• Slide the clamp along the T-Track to the desired position.
Position the clamp onto the workpiece.
• Tighten the knob to secure the workpiece and clamp in place.
TIPS
• Turn the feed handles on the drill press to makes sure they do
not interfere with the fence system. If needed, one or more of
the feed handles may need to be removed.
• When setting up using the 3/8" calibration hole in the center
of the table, the fence and T-Slot scales are set zeroed to the
drill bit, allowing accurate plus and minus settings from the
zero points. EXAMPLE: To drill a hole, 1" from the top of a
board and 8" from the left, perform the following:
-
Set the zero on the fence to the center point of the
drill bit. (Figure 14)
-
On both of the T-Track scales, set the fence at the
1" mark. (Figure 15,16)
-
Slide the flip stop on the left end to the 8" mark on the
fence scale and lock in place. (Figure 15,16)
-
Place the workpiece against the flip stop and fence
and drill the hole. (Figure 15,16)
Figure 14
Flipped DOWN
Figure 15
Figure 16
• Periodically check and make sure all knobs are tight
• Clean the drill press table/fence system after each use:
Fence Set to 1"
and secure.
-
Wipe the drill press table and vacuum all T-Slots in
the table and fence.
-
To prevent condensation and rust between the two
tables, DO NOT leave the drill press table mounted
on the drill press for long periods of time.
Visit us on the web at www.
Put these instructions and the original sales invoice in a safe,
dry place for future reference.
Southern Technologies, LLC
Waukegan, IL 60087
Flip Stop at 8"
powertecproducts.com
Advertisement
