Advertisement
3.
From underneath the drill press table, mark through the
slots for the location of the four attachment screws onto the
underside of the POWERTEC table.
4.
Remove the POWERTEC table, turn it upside down and
drill 5/32" pilot holes at the marks. DO NOT drill through
the table.
Figure 3
Underneath Drill Press Table
The marked location on the bottom of the POWERTEC table
5.
Place the POWERTEC table back onto the drill press table,
place the 3/8" bit through the calibration hole, square the
table and lock the spindle.
6.
Place a fender washer onto each #10 x 1-1/4" pan head
screw, from underneath the drill press table, thread the
screw into the pilot holes. DO NOT over tighten the screws,
over tightening can strip the holes.
Installation on T-Slotted Tables
Some larger drill presses have solid, T-Slotted tables. Follow
these instruction to mount the POWERTEC table.
1.
An adapter board will need to be made to mount the
POWERTEC table to this type of drill press table. Make
the adapter board approximately 15-1/2" x 23-1/2" x 3/4"
in thickness.
2.
Center the adapter board onto the drill press table and
select the location on the adapter board for the four
mounting bolts (provided 5/16"- 18 x 1" hex bolts). Mark
these locations, making sure they are perfectly centered to
the T-Slots in the drill press table. NOTE: The adapter board
must be centered on the drill press table with overlap on
each side.
The holes should be 3/8" in diameter. NOTE: The bolts
3.
must be flush to the adapter board. Counter-bored holes are
needed with the hex head bolts. Counter bored holes can
be made by using a forstner bit and a standard 3/8" drill bit.
If flat head screws are used a counter sunk hole is needed.
Most hardware stores sell countersink bits for this purpose.
4.
Attach the adapter board to the drill press table.
-
Insert the 5/16"- 18 x 1" hex bolts with 5/16" washers
through top of the adapter board and attach an oval
nut onto each bolt.
-
Slide the oval nuts in to the correct T-Slot on the
drill press table and tighten the bolts. Make sure the
adapter board table top is flush.
Mark Location for
Screws
Figure 4
Adapter Board
5/16"-18 x 1"
Hex Head Bolts
Oval Nut
T-Slotted Drill
Press Table
5.
Attach the POWERTEC table to the adapter board.
-
Place the POWERTEC table onto the adapter board.
-
From underneath the adapter board, pre-drill two
7/32" holes through the adapter board.
-
Making sure the POWERTEC table is centered on
the adapter board, pre-drill two 5/32" holes into the
bottom of the table. DO NOT drill through the table.
-
Use four #10 x 1-1/4" pan head screws to attach the
POWERTEC table to the adapter board.
Figure 5
POWERTEC Table
#10 x 1-1/4" Pan
Adapter Board
Head Screws
Table Insert
Refer to Figure 6–7
There is an opening in the table for the insert (filler), thread the
four adjustment screws into the recessed area of this opening as
shown in Figure 6.
Figure 6
Table Insert
T-Slotted Drill
Press Table
#6 x 1/2"Adjustment Screws
#6 x 1/2"Adjustment Screws
Advertisement
