Advertisement
6.
Place the insert into the opening and check with a straight
edge. Use a Phillips screw driver to adjust the screws until
the insert is flush with the top of the table.
Figure 7
Assemble Fence Mounting Blocks
Refer to Figure 8–10
1.
Insert two 1/4"-20 x 1-1/2" T-Bolts through the bottom of the
each mounting blocks and thread a knob (Item L) onto each
T-Bolt. Do not tighten.
2.
Slide the back T-Bolt into the T-Slot of the double-wide
T-Track (either track may be used depending on your
requirements). Make sure the overhang on the mounting
block is assembled to the front. It will be assembled to
the fence.
3.
Slide the front 1/4"-20 x 1" T-Bolt into the fence T-Slot
as shown.
4.
Repeat to assemble the other end of the fence to the table.
Figure 8
T-Track
Figure 9
36" Fence
T-Slot
Table Insert
Table
Knob
Fence
Mounting Block
1/4"-20 x 1-1/2"
T-Bolt
T-Slot
1/4"-20 x 1" T-Bolt
5.
Slide the fence horizontally across the table to the desired
position. Tighten the front knobs on the fence mounting
blocks to secure the fence to the mounting blocks.
6.
Slide the fence vertically into the desired position and
tighten the back knobs. This will lock the fence in position
onto the table.
Figure 10
loosen and
tighten these
knobs to slide
the fence
horizontally on
the table
To Adjust the Fence
Refer to Figure 10
• Loosen the two back knobs on the mounting blocks to slide
the fence vertically
• Loosen the two front knobs to slide the fence horizontally.
• Tighten the knobs securely to lock the fence in place after
each adjustment.
Flip Stop
Refer to Figure 1, 11–12
1.
Assemble 1/4"-20 x 1" T-bolt (Item D) and 1/4"-20 x 5/8"
round knobs (Item E) to flip stops (Item C) as shown in
Figure 1.
2.
Flip up the flip stop and slide the 1/4"-20 x 1" T-bolt into the
T-Slot to the front of the fence. Repeat on other side.
Figure 11
36" Fence
T-Slot
1/4"-20 x 1" T-Bolt
loosen and
tighten these
knobs to slide
the fence
vertically on
the table
Stop Flipped Up
Advertisement
