Advertisement
8.
Position Plywood so it sits almost flush with outside of floor joist framing (see Note). When
correctly positioned, attach to all floor joists with 1 1/4" screws. Use screws every 16".
B. Wall Section
Horizontal
Wall Cleats
Door Header
- Short (2)
Solid Wall
Panel (4)
9.
Locate 4 Solid Wall Panels and 4 Wall Plates (1 1/2" x 2 1/2" x 45 1/2"). Attach Plates to
bottom of studs of each wall panel with 3 - 2 1/2" screws. Position so plates are flush with framing.
Toll Free 1-888-658-1658
Note: Plywood is cut slightly smaller than
floor framing. Keep plywood seams tight.
Wall Plate (4)
Pilot hole ALL 2x3 Wall
Studs with 1/8" drill bit prior to
screwing. This will make it much
easier to attached together.
Wall Plate
www.outdoorlivingtoday.com
Exploded view of all parts necessary to
complete the Wall Section. Identify all parts
prior to starting.
Door Jambs (2)
Important:
Page 9
Wall Extendors (2)
Angled Wall
Extendors (2)
Door Header - Long
with aluminum
support.
Narrow Wall
Panel (2)
Pilot Hole
sales@outdoorlivingtoday.com
first.
Advertisement
