Advertisement
71.
To secure doors, you will need to install
the Interior Cane Bolt to the Vertical Door
Flange. First slide bolt through the upper and
lower brackets. Usually the upper bracket is
positioned between small nubs in the middle
of the bolt. Use 3/4" black screws to secure.
Screw on angle and make sure you attach to
door frame. Pre-drill to prevent wood from
cracking. Attach the holster high enough up
so the handle holds the bolt a few inches
above the door stop.
72.
Once the Cane Bolt is attached, close doors and mark a hole in the stop to accommodate the
bolt. You can bang the top of the bolt using a hammer and a block of wood to prevent damage.
Once complete, open doors and drill hole where previously marked with 1/2" bit.
73.
Attach Door Handles. Handles are
positioned on top section of each door and
mounted with 3/4" Black Screws.
Toll Free 1-888-658-1658
Drill 1/2" Diameter Hole
to accommodate rod of
Cane Bolt.
74.
with 2" & 3/4" Black Screws. Note how female part
of Barrel Bolt is positioned higher than male. Do a
dry run first to position Barrel Bolt correctly.
Important - Drill pilot holes with 1/8" drill bit prior to
securing with screws to prevent wood splitting. On
3/4" screw, drill shallow pilot hole only.
www.outdoorlivingtoday.com
Page 32
Bolt.
Important - Drill pilot holes
in Door Flange to prevent
wood from splitting.
2" Black Screws.
1 - 3/4" Black Screw.
Attach Black Barrel Bolt as illustrated above
sales@outdoorlivingtoday.com
Holster.
Upper and
lower brackets.
2" Black
Screws.
Advertisement
