Advertisement
35.
With Rafter Section correctly aligned, secure rafters to walls using 90° Metal Brackets. Start with
outside rafters and secure 2 Brackets with 1 1/4" screws. Screw into Wall Extension Framing at the
front, and Wall Panel top framing at the rear. Complete both sides.
Front
36.
With outside rafters properly secured, completely secure remaining interior rafters using
6 - 2 1/2" Screws. Screw into rafters from inside of Extension Wall framing at front of shed and inside
Rear Wall framing at rear of shed, behind Horizontal Wall Cleats.
2" overhang
37.
There are 3 different plywood roof panel sizes required to complete roof.
48" wide x 32" long x 2 pcs. - Long Plywood Roof Panel
48" wide x 21 3/4" long x 2 pcs. - Short Plywood Roof Panel
4" wide x 53 3/4" long x 1 pc. - Center Plywood Roof Panel
Starting with rear left corner, position 48" wide x 32" long panel on rafters.
Plywood will overhang outside rafter by 2". In the front, plywood will be recessed
1/8" back from rafter end.
Toll Free 1-888-658-1658
www.outdoorlivingtoday.com
Page 20
90° Metal Brackets
Rear
Sits on outside of middle rafter
1", and recessed 1/8" from edge
sales@outdoorlivingtoday.com
Advertisement
