Easy Auto Tuning - Canon GC-201 User Manual

7.3. Auto Tuning
Servo tuning of galvano scanner motors and controllers are set appropriately by Canon at the time of
shipping, however, an auto tuning function is included in the controller software in the following
situations for tuning again.
- When you want to replace a damaged mirror
- When oscillation occurs to change of the motor status or load status and you want to carry out
appropriate servo tuning
This auto tuning function can only be used when the following conditions have been met.
- The load to exchange (mirror, mirror holder) is the same design as the previous one
- The load is servo tuned once at Canon, and an auto tuning dedicated setting file is provided
(please contact your sales representative)
- Load attachment conditions for the motor are the same as the previous one
(The torque tightness of the mirror holder is the same, and torque tightness is listed on the
Inspection Sheet at the time of shipping)
Note:
In order to use this auto tuning function in this case, a dedicated setting file for the load is necessary.
This function is not for fully automatic tuning of an arbitrary (unknown) load.
CANON Digital Galvano Scanner System GM-1000 Series
Users Manual 1.20
81