Controller Led Display - Canon GC-201 User Manual

6.2. Controller LED Display

The controller (GC-201) is equipped with an LED that indicates the controller status.
After turning on the power, when the controller starts up normally, the display will be as follows.
LED1
(Blinks in approx 2 sec. intervals)
LED7
(Turns on)
Meaning of each LED
LED No.
LED1
LED2
LED3
LED4
CANON Digital Galvano Scanner System GM-1000 Series
Users Manual 1.20
LED2
(Blinks in approx 2 sec.intervals)
LED6
(Turns on)
Meaning
DSP1 operation (for Axis 1)
DSP1 operation (for Axis 2)
FPGA Start up
ALARM display (for Axis 1)
LED3
(Blinks in approx 1 sec. intervals)
Always blinks in approximately 2 sec. intervals if
DSP1 start up correctly.
Always blinks in approximately 2 sec. intervals if
DSP1 start up correctly.
Always lit if FPGA start up correctly.
This LED (red) is lit when a malfunction occurs with
the controller.
LED4 (Red)
(Not turns on)
LED5 (Red)
(Not turns on)
Remarks
72