Frigidaire PCFI3668AF Use & Care Manual page 27

Oven residual heat
When the display is in standby mode and the oven
cavity is still hot, the decreasing temperature bar
will be shown at the right side of the screen.
The temperature bar will disappear when the oven
cavity temperature decreases to below 140°F
(60°C).
Timing functions
Minute minder
The function of this timer is only to warn
the user when the set time has expired. It
does not stop any function in progress. It
can be activated either as a stand alone
timer or when setting a function, but its
operation is the same.
Timed cooking
This timer stops the function in progress
when the time has elapsed. It can only
be activated when setting a function.
Delayed cooking
This timer allows you to start a function
after the preset time. It can only be acti-
vated when setting a function and when
timed cooking has been set.
Minute minder
NOTE
• The minute minder can be set both during
cooking and as a stand alone timer.
• A minimum of 1 minute and a maximum of 12
hours can be set.
The minute minder allows you to set a timer and a
buzzer will sound at the end of the set time.
USING THE OVEN
Stand alone timer
The stand alone timer can be useful when cooking
with the induction cooktop.
With the display in standby mode:
1. Press the temperature knob. The screen will
show:
2. Turn the temperature knob left or right to set
the time.
3. Press the temperature knob to start the
timer.
During the countdown, you can change the previ-
ously set time by pushing and rotating the tem-
perature knob. Push the knob again to resume the
timer countdown.
When the timer expires, a buzzer sounds and the
clock icon starts to flash.
To stop the buzzer, simply interact with one of the
oven knobs or open the door, then the display
switches to standby mode.
Cooking timer
This timer mode acts as a stand alone timer during
a function in progress.
1. Set a manual cooking cycle (See "Manual
cooking") (example is a 350°F Bake).
2. Press the oven temperature knob until the
display shows the
the number ":00".
3. Set the time by turning the temperature
knob.
4. Keep pressing the temperature knob until
"START" flashes on the display. The
countdown starts immediately.
27
and icons and