Assembly / Attaching The Lower Handles - Gardenline 57774 User Manual

Assembly
Assembly
WARNING: Stop the engine and unplug the spark plug before any
repairs or maintenance operations.
WARNING: DO NOT attempt to start this mower without first adding
0.35L of SAE 10W/30 engine oil to the Engine.
WARNING: Do Not attempt to start this mower without the mower
first being FULLY assembled.
It is necessary to fit the lower handles (6), upper handle bar (1), and hard
catcher (7) to the
mower. (Fig A)
Attaching the Lower Handles
NOTE: The on/off control cable (3) is connected to the upper handle bar (1).
Be careful not to tangle the cable when removing the lawn mower from the
box, and during the upper and lower handle assembly.
1. To attach the lower handles (6), first remove the 2 x lower handle locking
knobs ( + bolt/s & curved washer/s) (8) from your accessory bag. Place
the lower handle in position by aligning the 2 x lower handle ends on the
inner side of the lower handle mounting plates (9).
2. Once in position, insert the bolt on each side through the lower
mounting plate (9) (Fig B) and then through the lower handle (6). (Fig C)
3. Once the bolts are loosely in position, fit the plastic curved washer over
the end of the bolt. Then screw the lower handle bar locking knob (8)
over the plastic curved washer and secure by turning clockwise until tight
and secure. (Fig D)
14
e-mail: help@powertoolsupport.com
MODEL: №. DM46P-DO140 • 08/2017 • 57774
A.
2 X SETS OF UPPER
HANDLE LOCKING LEVERS
4 Stroke Petrol Lawn Mower
2 X SETS OF LOWER
HANDLE LOCKING KNOBS
AFTER SALES SUPPORT
1800 909 909
(toll free)