Installing The Tensioner Pulley And Belt - Toro 78490 Operator's Manual

1
2
Figure 17
1. Bagger
2. Bagger mounting bracket
Installing the Tensioner Pulley
and Belt
1. Install the bagger belt onto the clutch drive pulley
(Fig. 20).
2. Route the bagger belt onto the bagger pulley
(Figures 18 and 20).
3. Remove the bolt, washer, spacer, and locknut from the
tensioner pulley arm (Fig. 18).
Note: Make sure the pulley is under the traction unit frame
when installing the tensioner pulley arm.
4. Install the tensioner pulley arm to the bagger with the
previously removed bolt, washer, spacer, and locknut
(Fig. 18).
3
4
m–6032
3. Hairpin cotter pin
4. Clevis pin
13
3
7
8
2
4
1
6
Figure 18
1. Bolt, 3/8 x 2–1/4 in.
2. Tensioner pulley and arm
3. Lock nut, 3/8 in.
4. Washer, 3/8 in.
5. Install the tensioner spring onto the bolt attached to the
bagger (Fig. 20).
Note: Make sure the bolt for the spring is set at 2 in.
(Fig. 19).
5
m–6008
5. Bagger
6. Skid plate
7. Bagger pulley
8. Spacer