Troubleshooting - WAGNER Studio Pro Owner's Manual

TROUBLESHOOTING

PROBLEM
Problem A: Little or no material flow
Problem B: Material leaking
Problem C: Spray pattern too thick, runs
and sags
Problem D: Spray jet pulsates
Problem E: Too much overspray
Problem F: Pattern is very light and
splotchy
*Only thin the material as a last resort to improve spray performance. Optimal
i
spray performance should be acheived simply by adjusting the various controls
on the unit.
This unit contains no servicable electrical parts. Do not attempt to service
yourself. Store indoors with the cord stored inside the Power Box.
Have you tried the recommendations above and are still having problems? In the
United States, to speak to a customer service representative, call our Technical Service
at 1-800-328-8251. See www.wagnerspraytech.com in the "Contact Us" section for
Technical Service hours.
16
EN
CAUSE
1. Nozzle clogged.
2. Suction tube clogged.
3. Material flow setting too low.
4. Suction tube loose.
5. No pressure build up in container.
6. Air filter clogged.
7. Spray material too thick.
8. Nozzle seal missing or worn.
1. Nozzle loose.
2. Nozzle worn.
3. Nozzle seal missing or worn.
4. Material build-up on air cap and nozzle
1. Material flow setting too high.
2. Air power setting too low.
3. Applying too much material.
4. Nozzle clogged.
5. Air filter clogged.
6. Too little pressure build-up in container.
7. Spray material too thick.
1. Material in container running out.
2. Air filter clogged.
1. Gun too far from spray object.
2. Air power setting too high.
1. Moving the spray gun too fast.
2. Material flow setting too low.
3. Air power setting too high.
SOLUTION
1. Clean.
2. Clean.
3. Increase material flow setting.
4. Remove and replace as tightly as possible.
5. Tighten container.
6. Change
7. Thin*.
8. Replace (extras provided).
1. Tighten.
2. Replace.
3. Replace (extras provided).
4. Clean.
1. Decrease material flow setting.
2. Increase air power setting.
3. Adjust material flow or increase
movement of spray gun.
4. Clean.
5. Change.
6. Tighten container.
7. Thin*.
1. Refill.
2. Change.
1. Reduce distance (3"-8" is ideal).
2. Decrease air power setting.
1. Adjust material flow or decrease
movement of spray gun.
2. Increase material flow setting.
3. Decrease air power setting.