Table of Contents
Advertisement
▪
Attach the right bracket and assemble the fittings as shown in Figure L-6.
Figure L-6: Attach bracket fittings to the product
▪
Push the right bracket up vertically as far as possible before tightening the fittings.
▪
Use the nut spinner and Allen key as listed in Table L-2 to tighten the fittings as
shown in Figure L-7 (recommended torque is 12 Nm).
▪
Repeat for the left bracket.
Figure L-7: Tighten the fittings
L.5.3
Attach the support bracket to the transformer along with the top isolators
The following tools and fittings as listed in Table L-3 and as shown in Figure L-8 are
required in order to attach the support bracket to the product with the top isolators.
Table L-3: Top isolators tools and fittings
Item No.
KAN01056
KAN03010
KAN02009
KAN03012
MECH09025
Note:
Shorter M6 bolts of 40mm (KAN01065) and 20mm (KAN01050) are also
supplied.
MA-005 - Minitrans Installation Manual - Rev 4.5
M6 x 20 bolt,
M6 flat
washer
Description
Qty
10 mm nut spinner
5 mm Allen key
M6 x 60 stainless
4
steel bolts
M6 flat washers
8
M6 nuts
4
M6 spring washers
4
Isolators
4
M6 flat
M6 nut
washer
M6 spring
washer
M6 nut, M6 spring, M6 flat &
M8 flat washers
Figure L-8: Top isolators tools and fittings
13-Aug-20
Large flat
washer
M6 flat
washer
Page 58 of 86
Advertisement
Table of Contents
