Club Car Carryall 300 2021 Maintenance And Service Manual page 57

ACCELERATOR AND BRAKE PEDAL GROUP
2999
Figure 5-2 Brake Pedal Weldment Through Floor
3. Position and attach brake pedal assembly, mounting blocks (3 and 7), and washers (9) to vehicle frame as shown.
Tighten the bolts (10) and nuts to 95 in·lb (10.7 N·m). Figure 5-1, Page 5-2
4. Tighten the nut (2) on the equalizer rod (1) so that brake pedal free-play is from 1/4 inch to 1/2 inch (6 mm to 13
mm) (Figure 5-3, Page 5-3). See following NOTE.
NOTE: Brake pedal free-play is the distance the brake pedal can be pressed before the brake actuator arm moves.
5. Tighten the jam nut (3) while holding the adjustment nut (2) in the correct position.
6. Adjust the pedal group. Refer to the appropriate adjustment procedure:
– For gasoline vehicles, see Pedal Group Adjustment – Gasoline Vehicles on page 5-10.
– For electric vehicles, see Pedal Group Adjustment – Electric Vehicles on page 5-15.
Dimension A: 1/4 inch to 1/2 inch (6 mm to 13 mm)
Note: Equalizer bracket may be inverted on some vehicles.
1369
Brake Pedal and Park Brake (Gas and Electric Vehicles)
2
1
Figure 5-3 Brake Pedal Free-Play Adjustment
A
3
2021 Carryall 300 Maintenance and Service Manual
5
Page 5-3