Bosch Rexroth SD301 Manual page 21

3 609 929 827/06.06 | SD301
4 Assembly
4.2 Sliding the display onto the
holder
The system display is placed on the holder's
enclosure side groove and pushed back
lightly until it reaches the stopper.
SBH301 SBH301
Figure 7: Sliding the SD301 system display onto the
SBH301
The SD301 system display can be taken off
the holder for operations.
4.3
4.3.1
The system display is connected to the tight-
ening controller's X6 interface with the con-
necting cable. Use the connection cable in
chapter 7.2 „Accessories" for this purpose.
4.3.2
Connection cables for extra power supply
NI0-QUITT
(see chapter
0
EC 37 USP TFVM
EC 48 NTF BTBVM
ed for connections to tightening controllers
MOTOR
SE301 and KE300.
RESET
OFFSET T n
GAIN I m
BTB
FG LI
FGI ST1
PV ST2
FI ST3
BL TF
Figure 8: Connection to SE301, KE300
The black lead is connected to a 0 V terminal
(pin 5, 6, or 7), and the black lead with a red
line to the +24 V terminal (pin 1) of interface
X4 on the VM300. The power can also be
supplied by an SE3x1, SE3x2 or SEH3x2 (in-
terface X7: +24 V to pin 5, 0 V to pin 6).
Bosch Rexroth AG
Connecting the system
display
Connection to SE302, SE31x,
SEH3x2, KE31x
Connection to SE301, KE300
7.2 „Accessories"
VM300
x4
24V
0V
+24V/0V
Important:
Always connect the +24 V/0 V ca-
bles when using connection ca-
bles for extra power supply.
21/76
) are need-