Pnp/Pci Configurations; Init Display First; Reset Configuration Data; Resources Controlled By - mATX AIMB-763 Series User Manual

2.8 PnP/PCI Configurations

2.8.1

Init Display First

This item allows you to choose the first display interface to initiate while
booting. The choice is "PCI Slot" or "Onboard".
2.8.2

Reset Configuration Data

The default is "Disabled". Select Enabled to reset Extended System Con-
figuration Data (ESCD) if you have installed a new add-on card, and sys-
tem configuration is in such a state that the OS cannot boot.
2.8.3

Resources Controlled By

The commands here are "Auto(ESCD)" or "Manual". Choosing "Man-
ual" requires you to choose resources from the following sub-menu.
"Auto(ESCD)" automatically configures all of the boot and Plug and Play
devices, but you must be using Windows 95 or above.
2.8.4

PCI/VGA Palette Snoop

This is set to "Disabled" by default.
2.8.5

Maximum Payload Size

This allows you to set the maximum TLP payload size for PCI Express
devices. The options are [128 bytes], [256 bytes], [512 bytes], [1024
bytes], [2048 bytes], and [4096 bytes].
Figure 2.11: PnP/PCI configurations screen
65 Chapter 2 BIOS setup