Table of Contents
Advertisement
Notes
It is recommended that you connect a high-definition front panel
audio module to this connector to avail of the motherboard's high-
definition audio capability.
12.
Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or
switch. Connect one end of the chassis intrusion sensor or switch cable to
this connector. The chassis intrusion sensor or switch sends a high-level
signal to this connector when a chassis component is removed or
replaced. The signal is then generated as a chassis intrusion event.
By default, the pins labeled "Chassis Signal" and "Ground" are shorted
with a jumper cap. Remove the jumper caps only when you intend to use
the chassis intrusion detection feature.
AIMB-763 User Manual
Figure 1.40: Chassis Intrusion Connector
42
Advertisement
Table of Contents
