Table of Contents
Advertisement
2.7.7
Video Off In Suspend
When the system is in suspend mode, the video will turn off. The choices
are "No" and "Yes".
2.7.8
Suspend Type
The choices are "Stop Grant" and "PwrOn Suspend".
2.7.9
Suspend Mode
Please refer to 2.7.5.
2.7.10 HDD Power Down
Select "1-15 mins" to enable HDD Power Down mode between 1 to 15
mins. Select "Disabled" to disable HDD Power Down function.
2.7.11 Soft-Off by PWR-BTTN
If you choose "Instant-Off", then pushing the ATX soft power switch but-
ton once will switch the system to "system off" power mode. You can
choose "Delay 4 sec". If you do, then pushing the button for more than 4
seconds will turn off the system, whereas pushing the button momentarily
(for less than 4 seconds) will switch the system to "suspend" mode.
2.7.12 Wake-Up by PCI card
The choices are "Enabled" and "Disabled".
2.7.13 PowerOn by Ring
Select "Enabled" to power on the system from a soft off state by an input
signal on the serial Ring Indicator (RI) line. The choices are "Enabled"
and "Disabled".
2.7.14 USB KB Wake-Up From S3
When "Enabled", enter any key to wake up the system from S3 state. The
choices are "Enabled" and "Disabled".
2.7.15 Resume by Alarm
When "Enabled", set the date and time at which the RTC (real-time
clock) alarm awakens the system from suspend mode. The choices are
"Enabled" and "Disabled".
2.7.16 Primary IDE 0 (1) and Secondary IDE 0 (1)
When Enabled, the system will resume from suspend mode if Primary
IDE 0 (1) or Secondary IDE 0 (1) becomes active. The choices are
"Enabled" and "Disabled".
63
Chapter 2 BIOS setup
Advertisement
Table of Contents
