Table of Contents
Advertisement
2.6.13 Onboard LAN2 Control
Options are "Enabled" and "Disabled". Select Disabled if you don't want
to use the onboard LAN controller2.
Figure 2.8: Super I/O Device
2.6.14 POWER ON Function
This feature allows you to wake up the system using any of the listed
options. The selections are "Hot KEY", "Mouse Left", "Mouse Right",
"Any KEY" and "BUTTON ONLY".
2.6.15 Hot Key Power On
Awaken the system by pressing the hot key button. The choices are "Ctrl-
F1", "Ctrl- F2", "Ctrl-F3" to "Ctrl-F8".
2.6.16 Onboard FDC Controller
When enabled, this field allows you to connect your floppy disk drives to
the onboard floppy disk drive connector instead of a separate controller
card. If you want to use a different controller card to connect the floppy
disk drives, set this field to Disabled.
2.6.17 Onboard Serial Port 1
The settings are "3F8/IRQ4", "2F8/IRQ3", "3E8/IRQ4", "2E8/IRQ3",
and "Disabled" for the on-board serial connector.
59
Chapter 2 BIOS setup
Advertisement
Table of Contents
