HUBBELL LIGHTING Compass tradeSELECT CJB Quick Start Manual

INSTRUCTION FOR EMERGENCY
I
I
PAC6060W-P

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should always be followed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
INSTRUCTION FOR EMERGENCY
1. Rated for temperature range of 10 -40
2. Used indoors only.
LIGHTING FIXTURE
3. Equipment should be mounted in locations and at heights where it will not be subject to tampering by unauthorized
personnel.
4. Do not mount near gas or electric heaters.
IMPORTANT SAFEGUARDS
5. The use of accessory equipment is not recommended by the manufacturer and may cause an unsafe condition.
6. Do not use this equipment for anything other than its intended use.
When using electrical equipment, basic safety precautions should always be followed including the following
7. Servicing of this equipment should be performed by qualified personnel.
READ AND FOLLOW ALL SAFETY INSTRUCTIO
8. Disconnect AC power before servicing.
SAVE THESE INSTRUCTIONS!
1. Rated for temperature range of 10 -40
PAC6060W-P PAC6060W-E
2. Used indoors only.
3. Equipment should be mounted in locations and at heights where it will not be subject to tampering by u

INSTALLATION (J-BOX MOUNTING)

1. Before installation, use a tool to remove the faceplate. (Fig 1)
4. Do not mount near gas or electric heaters.
1. Before installation, use a tool to remove the faceplate. (Fig 1)
1. Before installation, use a tool to remove the faceplate. (Fig 1)
1. Connect the battery wire.（Fig 1，Fig 2）
5. The use of accessory equipment is not recommended by the manufacturer and may cause an unsafe condi
2. Connect input wire of 120/277 to AC power （universal voltage from 120V-277V） ， then put the whole unit into J-box,
6. Do not use this equipment for anything other than its intended use.
fix it by using screws on corner, then put on the face cover. (Fig 3)
7. Servicing of this equipment should be performed by qualified personnel.
4.
3. Turn on the AC power and press the "TEST" button to check the light.
8. Disconnect AC power before servicing.
4. 4.
SAVE THESE INSTRUCTIONS!
INSTALLATION (J-BOX MOUNTING)
1. Connect the battery wire.（Fig 1，Fig 2）
2. Connect input wire of 120/277 to AC power （universal voltage from 120V-277V） ， then put the whole uni
3. Turn on the AC power and press the "TEST" button to check the light.
Fig 1
LIGHTING FIXTURE
IMPORTANT SAFEGUARDS
WARNING: RISK OF ELECTRIC SHOCK- NEVER CONNECT TO, DISCONNECT FROM,
INSTRUCTION FOR EMERGENCY
WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS AND WARNINGS MAY
RESULT IN DEATH, SERIOUS INJURY OR SIGNIFICANT PROPERTY DAMAGE.
For your protection, read and follow these warnings and instructions carefully before
PAC6060W-E
installing or maintaining this equipment. These instructions do not attempt to cover all
READ AND FOLLOW ALL SAFETY
1. Rated for temperature range of 10℃ to 40℃ (50℉ to 104℉).
2. Used indoors only.
3. Equipment should be mounted in locations and at heights where it will not be subject to
(50 -104 ) .
tampering by unauthorized personnel.
4. Do not mount near gas or electric heaters.
5. The use of accessory equipment is not recommended by the manufacturer and may cause
an unsafe condition.
PAC6060W-P
6. Do not use this equipment for anything other than its intended use.
7. Servicing of this equipment should be performed by qualified personnel.
8. Disconnect AC power before servicing.
IMPORTANT!
NOTE:
The battery in this unit may not be fully charged. After
electricity is connected to unit, let battery charge up for at
least 24 hours. Then the normal operation of this unit should
take effect. To check, press the "TEST" button and the lights
on the unit should turn ON.
personnel.
(Fig 2, Fig 3)
(Fig 2, Fig 3) (Fig 2, Fig 3)
(50 -104 ) .
fix it by using screws on corner, then put on the face cover. (Fig 3)
IMPORTANT!
The battery in this unit may not be fully charged. After
electricity is connected to unit, let battery charge up for at
OR SERVICE WHILE EQUIPMENT IS ENERGIZED.
least 24 hours. Then the normal operation of this unit should
take effect. To check, press the "TEST" button and the lights
on the unit should turn ON.
LIGHTING FIXTURE
installation and maintenance situations.
INSTRUCTIONS
PAC6060W-E
(50 -104 ) .

INSTALLATION

(Fig 4)
(Fig 4) (Fig 4)
Fig 2
J-Box Mounted Emergency Light
IMPORTANT!
The battery in this unit may not be fully cha
electricity is connected to unit, let battery charg
least 24 hours. Then the normal operation of this
take effect. To check, press the "TEST" button a
on the unit should turn ON.
CJB