HUBBELL LIGHTING DUAL LITE CLS Series Installation Instructions

Hubbell Lighting, Inc. Life Safety Products • www.dual-lite.com
Copyright Hubbell Lighting, Inc., All Rights Reserved • Specifications subject to change without notice. • Printed in U.S.A.
©
INSTALLATION INSTRUCTIONS FOR
CHICAGO APPROVED LED EXIT OR STAIRS SIGN
READ AND FOLLOW
ALL SAFETY
INSTRUCTIONS!
IMPORTANT SAFEGUARDS
WARNING: RISK OF ELECTRIC SHOCK - NEVER CONNECT TO, DISCONNECT FROM, OR SERVICE WHILE EQUIP-
IMPORTANT SAFEGUARDS
MENT IS ENERGIZED.
WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS AND WARNINGS MAY RESULT IN DEATH, SERIOUS
When using electrical equipment, basic safety precautions should always be followed including the following.
INJURY OR SIGNIFICANT PROPERTY DAMAGE - For your protection, read and follow these warnings and instructions
carefully before installing or maintaining this equipment. These instructions do not attempt to cover all installation and mainte-
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
nance situations.
1. Do not let power supply cords touch hot surfaces.
WARNING: RISK OF FIRE - Lamps are hot. Keep combustible material away from hot parts. Observe lamp manufacture
2. Do not mount near gas or electric heaters.
warnings, recommendations and restrictions on lamp operation and maintenance. Make sure lamps are correctly installed.
3. Equipment should be mounted in locations and at heights where it will not readily be subject to tampering
by unauthorized personnel.
• All service shall be performed by qualified service personnel. This product must be installed and maintained in accordance
4. The use of accessory equipment not authorized by the manufacturer may cause an unsafe condition.
with the applicable installation codes by a person familiar with the construction operation of the product and the hazards
5. Do not use this equipment for other than its intended purpose.
involved.
6. Servicing of this equipment should be performed by qualified service personnel.
• This product must be installed in accordance with the applicable installation codes and ordinances.
7. Test cycling: the Life Safety Code (NFPA 101) requires testing of emergency exit signs once a month for a
• Before wiring to power supply, turn off electricity at fuse or circuit breaker.
minimum of 30 seconds and once a year for a minimum of 90 minutes.
• Disconnect A.C. power and unplug battery before servicing.
• Consult your local building code for approved wiring and installation.
• May be used outdoors under cover. (0°C-50°C)
• Do not let power supply cord touch hot surfaces. •SEE UNIT LABEL FOR ADDITIONAL MODEL SPECIFICATIONS
• Do not mount near gas or electric heater.
•SAVE THESE INSTRUCTIONS FOR USE BY OWNER/OCCUPANT
• Equipment should be mounted in Iocations and at heights where it will not readily be subjected to tampering by unauthorized
personnel.
• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
• Do not use this equipment for other than intended use.
• The AC voltage rating of this equipment is specified on the product label. Do not connect equipment to any other voltage.
WARNING –
This product contains chemicals known to the State of California to cause cancer, birth defects and/or other
reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.
SAVE THESE INSTRUCTIONS AND
DELIVER TO OWNER AFTER INSTALLATION.
93041209 2/12
INSTALLER:
PAGE 1
CLS Series
LED Steel Exit Sign
Hubbell Lighting, Inc.