HUBBELL LIGHTING Compass CELEM Installation Instructions

CELEM
RECESSED EMERGENCY LIGHT
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1. Review the diagrams thoroughly before beginning.
2. All electrical connections must be in accordance with local codes, ordinances, and the National Electric code.
3. Disconnect power at fuse or circuit breaker before installing or servicing.
4. Do not use outdoors.
5. Do not mount in hazardous locations, or near gas or electric heaters.
6. Do not let power cords touch hot surface.
7. Equipment should be mounted in locations and at heights where it will not be subjected to tampering by
unauthorized personnel.
8. The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
9. Do not use this equipment for other than intended use.
10. All servicing should be performed by qualified personnel only.
11. Allow battery to charge for 24 hours before first use.
W IRING DIAGRAM (SE E F IG 1 )
Page 1/2 Rev. 06/08/20
COM-CELEM-INST

IMPORTANT SAFEGUARDS

SAVE THESE INSTRUCTIONS
© 2020 Columbia Lighting, a division of Hubbell Lighting, Inc. Specifications subject to change without notice.
701 Millennium Blvd • Greenville, SC 29607 / Tel 864.678.1000 / Website www.columbialighting.com
Installation Instructions
Use Flexible Conduit Only
Orange 277VAC
Black 120VAC
White Neutral
2nd Battery
1st Battery