Safety Measures - Maxwell MW-3006 Manual Instruction

ENGLISH
IRON MW-3006
The iron is intended for ironing clothes and bed-
ding and for vertical steaming of fabrics.
DESCRIPTION
Water spray
1.
Water inlet lid
2.
"Continuous steam supply/self-clean" switch
3.
Burst of steam button
4.
Water spray button
5.
Handle
6.
Heating element ON/OFF indicator
7.
Power cord protection
8.
Base
9.
Water tank
10.
Temperature control knob
11.
Maximum water level mark
12.
Soleplate
13.
Beaker
14.
ATTENTION!
For additional protection it is reasonable to install
a residual current device (RCD) with nominal
operation current not exceeding 30 mA. To install
RCD, contact a specialist.

SAFETY MEASURES

Before using the electrical unit, read this instruc-
tion manual carefully and keep it for future refer-
ence.
Use the unit for its intended purpose only, as
specified in this manual. Mishandling of the unit
may lead to its breakage and cause harm to the
user or damage to property.
•
Before switching the unit on, make sure that
your home mains voltage corresponds to the
unit operating voltage.
•
The power cord is equipped with a «euro-
plug»; plug it into the socket with a reliable
grounding contact.
•
To avoid fire, do not use adapters for plug-
ging the unit in.
•
To avoid mains overloading, do not switch on
several electrical appliances with high power
consumption at a time.
•
Do not use the iron outdoors and in places
with high humidity.
•
Place the iron on a flat stable surface or use
a stable ironing board.
•
ATTENTION! The surfaces of the iron get hot
during operation. Avoid contact of open skin
areas with the iron's hot surfaces or outgoing
steam to avoid burns.
•
Do not fill the water tank with scented liquids,
vinegar, starch solution, descaling reagents,
chemicals etc.
•
Do not switch the unit on in places where
aerosols are sprayed or highly flammable liq-
uids are used.
•
To avoid damaging the soleplate non-stick
coating be very careful when ironing clothes
with metal zippers or buttons.
• Make sure that the power cord is not on the
ironing board and it doesn't touch hot sur-
faces and sharp edges.
• Never leave the unit connected to the mains
unattended. During breaks in operation and
when the iron is cooling down, put the iron on
the base (in vertical position).
•
Before plugging/unplugging the iron, set the
temperature control knob to the minimum
position and switch the continuous steam
supply off.
• Always unplug the iron if you are not using it.
•
Always take the power plug out of the mains
socket before filling the water tank with
water.
•
The water inlet lid should be closed during
ironing.
•
To unplug the iron, always hold the power
plug, do not pull the power cord.
• To avoid electric shock, do not immerse the
iron, the power cord and the plug into water
or any other liquids.
•
Before taking the iron away, let it cool down
completely and pour out the remaining
water.
•
Pour out water from the water tank only after
unplugging the iron.
• Clean the unit regularly.
•
Do not touch the unit body and the power
plug with wet hands.
•
Do not allow children to touch the iron body
and the power cord during operation.
• Do not leave children unattended to avoid
them using the unit as a toy.
•
For children safety reasons do not leave
polyethylene bags, used as packaging, unat-
tended.
Attention! Do not allow children to play with
polyethylene bags or packaging film. Danger
of suffocation!
8