two lines intersection point and angle
intersection
point
coordinate
After the two lines intersection point and angle calculation, the INC coordinate of the ES-9Q will be
preset to the intersection point of line 1 & 2, operator move to 0.000 in INC coordinate, then this
is the intersection point of the line 1 & 2..
3. After operator viewed the intersection point feature's parameters, operator can store this point
feature into the memory of ES-9Q as per following procedure.
press
key to store the feature into the memory
Store
15.846
-1.526
60.01.15
Q
There are 100 feature memory available in ES-9Q, they are feature 0-99 respectively, in this example, we
are going to store this point parameters as feature 09, procedure are as follows
15.846
-1.526
60.01.15
Q
CROSS PT
CROSS PT
15.846
Polar
Store
Recall
R/D
Print
XY
-1.526
Enter
Q
FI N I S H
RESULT
Store
Polar
Store
Recall
R/D
Print
XY
Enter
FI N I S H
SEL 0-99
Polar
Store
R/D
Print
Recall
XY
Enter
FI N I S H
2-axes display
over angle
supplmnty
anglel
enter the feature memory
location. then the point parameters
Enter
are store into memory location
as feature 09.
- 23 -
ANGLE
60.01.15
Polar
Store
Recall
R/D
XY
119.58.45
Q
ES-9Q asking the feature memory
location to be stored.
15.846
SEL 0-99
Polar
Store
Recall
R/D
XY
-1.526
60.01.15
Q
Print
Enter
FI N I S H
Print
Enter
FI N I S H