Advertisement
6. After operator viewed the circle feature's parameters ( centre and Dia/Rad ), operator can store this circle
feature into the memory of ES-9Q as per following procedure.
press
key to store the feature into the memory
Store
Q
There are 100 feature memory available in ES-9Q, they are feature 0-99 respectively, in this example, we
are going to store this circle parameters as feature 02, procedure are as follows
4.654
-1.072
3.985
Q
After the 3 point circle measurement, the INC coordinate of the ES-9Q will be preset to the centre
coordinate of the circle to be measured. operator move to 0.000 in INC coordinate, then this is the centre
F 1
of the circle to be measured.
0,0
b) Recall three points features or circle features from memory to construct a circle
1. Press the
key to enter into 3 point circle function
Q
3 points to construct a circle function
Polar
Store
Recall
R/D
Print
XY
Enter
FI N I S H
SEL 0-99
Polar
Store
R/D
Print
Recall
XY
Enter
FI N I S H
Polar
Store
Recall
R/D
Print
XY
Enter
FI N I S H
Store
Enter
enter the feature memory
location. then the circle parameters
are store into memory location
as feature 02.
-5.000
INC
Polar
Store
R/D
Recall
Print
XY
-4.000
Enter
FI N I S H
Q
- 12 -
ES-9Q asking the feature memory
location to be stored.
4.654
SEL 0-99
Polar
XY
-1.072
3.985
Q
message window displays
requesting enter the point no. 1
POINT 1
Polar
XY
Q
Store
Recall
R/D
Print
Enter
FI N I S H
ENT PT.1
Store
Recall
R/D
Print
Enter
FI N I S H
Advertisement
