Troubleshooting; Maintenance; Repairs; Environmental Protection - eisenblatter TOPRAIL 1100 HT Original Instructions Manual

12. Troubleshooting

The electronic signal indicator (A2-10) lights
up and the load speed decreases.
There is too much load on the machine! Run the
machine in idling until the electronic signal indicator
switches off.
The machine does not start. The electronic
signal indicator (A2-10) flashes.
The restart protection is active. If the mains plug is
inserted with the machine switched on or if the power
supply is restored following an interruption, the machine
does not start up. Switch the machine off and back on
again.

13. Maintenance

Disconnect the mains plug or remove the battery pack
from the machine before starting any maintenance work.
It is possible that particles deposit inside the power tool
during operation. This impairs the cooling of the power
tool. Conductive build-up can impair the protective
insulation of the power tool and cause electrical hazards.
The power tool should be cleaned regularly, often and
thoroughly through all front and rear air vents using a
vacuum cleaner or by blowing in dry air.
Prior to this operation, separate the power tool from the
power source and wear protective goggles and a dust
mask.
13.1 Change the drive roller
See page 3, figures E1 and E2.
Hold down the spindle locking button (A1-4) and
unscrew the drive roller (A2-7).
Then screw the new drive roller back on.
www.eisenblaetter.de
Original instructions TOPRAIL 1100 HT

14. Repairs

Repairs to power tools must only be carried out by
qualified electricians!
If the connection lead is damaged, it must be replaced
by a special connection lead.
Contact your sales agency or Eisenblätter if you have
Eisenblätter power tools requiring repairs:
Gerd Eisenblätter GmbH
Jeschkenstraße 12d
82538 Geretsried
info@eisenblaetter.de
www.eisenblaetter.de

15. Environmental protection

The generated sanding dust may contain harmful
substances: dispose of appropriately.
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
tools, packaging and accessories.
Only for EU countries: never dispose of power
tools in your household waste! In accordance
with European Directive 2002/96/EC relating
to electrical and electronic waste and implementation of
national law, used electrical tools must be collected
separately and disposed of in an environmentally friendly
manner at recycling centres.
EN
19