Attaching The Tools, Working Notes; Switching On And Off - eisenblatter TOPRAIL 1100 HT Original Instructions Manual

EN
Original instructions TOPRAIL 1100 HT

10. Attaching the tools, working notes

Prior to any conversion work: Pull the mains plug
out of the socket or remove the battery pack from
the machine. The machine must be switched off and at a
standstill.
10.1 Belt change
See page 2, figure C.
Load the front guide arm (A1-2) by pressing lightly on
the handle (spring tension).
Then you can remove the belt from the two pulleys (A2-4
and A2-5) and from the drive roller (A2-7).
Inserting a new tape is carried out in the same way.
After threading, the tape is automatically tensioned
as soon as you relieve the front guide arm. When the
electrical device is switched on, the belt in the center is
automatically adjusted.
10.2 Working on round pipes
Siehe Seite 2, Abbildungen D1 und D2.
The machine is placed on the pipe in the middle
between the small deflection roller (A2-4) and the drive
roller (A2-7) – see Figure D1.
By pressing the adjustable additional handle (A2-1), the
entire bracket mechanism is placed over the pipe to be
ground (support approx. 50% of the pipe circumference)
– see Figure D2.
The entire pipe can now be processed by moving the
machine sideways and swiveling it.
18

11. Switching on and off

Always guide the machine with both hands.
Switch on first, then guide the accessory towards
the workpiece.
Avoid inadvertent starts: always switch the tool off
when the plug is removed from the mains socket
or if there has been a power cut.
The machine must not be allowed to draw in
additional dust and shavings. When switching the
machine on and off, keep it away from dust deposits.
After switching off the machine, only place it down when
the motor has come to a standstill.
In continuous operation, the machine continues
running if it is forced out of your hands. Therefore,
always hold the machine with both hands using the
handles provided, stand securely and concentrate.
Switching on:
Push the sliding switch (A2-9) forwards.
For continuous operation, now tilt it downwards until it
engages.
Switching off:
Press the rear end of the sliding switch (A2-9) and
release it.
www.eisenblaetter.de